Safety Instructions - HBM QUANTUM X Bedienungsanleitung

1

Safety instructions

CANBus
Notice
The safety instructions described here also apply to the
power pack NTX001 and the active backplane BPX001
and BPX002.
Appropriate use
A module integrated into the CANbus by the relevant
connector is to be used exclusively for measurement and
test tasks. Use for any purpose other than the above is
deemed to be non-designated use.
To ensure safe operation, the module must only be ope­
rated as described in the general operating manual and in
accordance with the information detailed in this document.
It is also essential to comply with the legal and safety re­
quirements for the application concerned during use. The
same applies to the use of accessories.
Each time you start up the module, you must first run a
project planning and risk analysis that takes into account
all the safety aspects of automation technology. This par­
ticularly concerns personal and machine protection.
Additional safety precautions must be taken in plants
where malfunctions could cause major damage, loss of
data or even personal injury. In the event of a fault, these
precautions establish safe operating conditions.
This can be done, for example, by mechanical
interlocking, error signaling, etc.
A4461-2.0 HBM: public
Safety instructions
5