Data Bit Numbering Systems According To The Vector Dbc Format; Numbering Systems Used In Quantumx / Somatxr Parameterization - HBM QUANTUM X Bedienungsanleitung

CANBus
Type = MeasVal
DataFormat = REAL32
Factor = 1.0
Offset = 0.0
StartBit = 0 bzw. 7 (depending on „BitSequence")
SignalLength = 32
BitSequence = INTEL or MOTOROLA
CanMessage TransmissionType = "Control" or
"Timer"
A received CAN message cannot be forwarded via CAN.
The signal source must also be taken from within the
module, that is:
ModuleReference (empty or "UUID=[own UUID]"),
SignalReference = "AnalogIn_Connector[2...8].Sig­
nal1"
The parameters from <ValueOnError> are supported.
For timer-controlled transmission, a measured value can
only be sent every 10 ms, or less often. Please note that
up to and including firmware version 4.4, the parameter
<Period> has been given in milliseconds. To ensure that
the future use of this parameter is the same as in the
MX471B, <Period> must be given in microseconds in the
MX840B as well in future, with a resolution of 1000 μs.
6.6 Data bit numbering systems
according to the vector DBC format
6.6.1 Numbering systems used in QuantumX /
SomatXR parameterization
The data for the measured values can be interpreted in
different numbering systems.
A4461-2.0 HBM: public
Functional description
49