HBM QUANTUM X Bedienungsanleitung Seite 64

QuantumX / SomatXR and CCP / XCP-on-CAN
62
Step 1 - Create Measurement Configuration using
CANape
S ·Create new CANape project
S ·Create new CCP or XCP device, depending on the
protocol that is implemented on the ECU
S ·Create a measurement configuration with all the
signals that you want to record with MX471B. Take
care that measurement mode is cyclic. Polling mode
is not yet suported.
Step 2 – Configure "Seed & Key" option and adjust
"Init" settings using CANape
S ·If the ECU does not support "Seed & Key" option you
have to disable it in the Protocol Settings of the
Device Configuration
S ·If the ECU supports "Seed & Key" you have to select
the *.skb file.
A4461-2.0 HBM: public
CANBus