Integer Scaling - HBM QUANTUM X Bedienungsanleitung

Functional description
36
QuantumX / SomatXR system, includes a name
(<ChannelName>) and an ID specifying whether this
name was set by the user or taken from the default
settings (<OriginOfName>).
6.4.6

Integer scaling

If the values for both "factor" and "offset" have been
parameterized with an integer, particular emphasis is
given to the accuracy of the integer. The aim is to avoid
rounding errors that are critical if the integer values rep­
resent boolean states.
The "raw_value" raw data are also taken from the CAN
bus in the raw data format ("RawValueFormat") first, but
are then converted to a calculation format that depends
on the data type of "signal_value" ("SignalFormat"), as
given in the table below. The "factor" and "offset" are also
calculated with the data type given in the table. The inter­
mediate result is ultimately converted to the data format
specified as the "SignalFormat".
The table below only applies to the "integer scaling"
described here.
A4461-2.0 HBM: public
CANBus