Receiving Can Messages - HBM QUANTUM X Bedienungsanleitung

QuantumX / SomatXR and CAN
Constant green
Flashing yellow
Yellow on
Red on
Green on
Flashing yellow
22
CAN LEDs (channel)
Channel is ready for operation
Firmware download active
Boot process running
Channel has errors
Ethernet LED (only QuantumX)
Ethernet link status is OK
Ethernet data transmission ongoing
5.2.2

Receiving CAN messages

To be able to receive CAN messages, the node must be
able to identify the relevant messages. This can be done
directly on the node or, in a reproducible way, by previ­
ously generated messages in the sensor database. Indi­
vidual messages can be linked to the node by dragging
from the sensor database and dropping them where re­
quired.
CAN databases type *.dbc can also be read into the
sensor database. If no CAN database is available, it can
also be created. Editors for this purpose are provided by
different companies.
Received CAN messages are instantly "time-stamped" in
measurement mode. This enables directly acquired
measured quantities and CAN messages to be acquired
and analyzed in parallel and synchronously in the entire
system.
A4461-2.0 HBM: public
CANBus