HBM QUANTUM X Bedienungsanleitung Seite 11

Safety instructions
Working safely
The supply connection, as well as the signal and sensor
leads, must be installed in such a way that
electromagnetic interference does not adversely affect
device functionality (HBM recommendation: "Greenline
shielding design", downloadable from the Internet at
http://www.hbm.com/Greenline).
Automation equipment and devices must be covered
over in such a way that adequate protection or locking
against unintentional actuation is provided (e.g. access
checks, password protection, etc.).
When devices are working in a network, these networks
must be designed in such a way that malfunctions in
individual nodes can be detected and shut down.
Safety precautions must be taken both in terms of
hardware and software, so that a line break or other
interruptions to signal transmission, e.g. via the bus
interfaces, do not cause undefined states or loss of data
in the automation device.
Error messages should only be acknowledged once the
cause of the error is removed and no further danger
exists.
Conversions and modifications
The module must not be modified from the design or
safety engineering point of view except with our express
agreement. Any modification shall exclude all liability on
our part for any resultant damage.
In particular, any repair or soldering work on
motherboards (exchanging components) is prohibited.
When exchanging complete modules, use only original
parts from HBM.
CANBus 9
A4461-2.0 HBM: public