Initial Settings Menu - Yamaha MCR-840 Bedienungsanleitung

DVD SETUP MENU OPTIONS
2
Select "Video Adjust", and then press
ENTER.
The Video Adjust menu appears on-screen.
Video Adjust
Sharpness
Brightness
Contrast
Gamma
Hue
Chroma Level
3
Use / / / and ENTER to select and
change the settings.
The settings are explained below.
The Brightness, Contrast, Hue, and Chroma Level
settings can be adjusted by using
Brightness min
4
Press SETUP to close the Setup menu.
■ Sharpness
Adjusts the sharpness of edges in the picture.
• Fine, Standard (default), Soft.
■ Brightness
Adjusts the brightness of the picture.
• –20 to +20 (default: 0)
■ Contrast
Adjusts the contrast between the lightest and darkest areas
of the picture.
• –16 to +16 (default: 0)
■ Gamma
Adjusts the appearance of dark areas of the picture.
• High, Medium, Low, Off (default).
■ Hue
Adjusts the balance between green and red.
• green 9 to red 9 (default: 0)
■ Chroma Level
Adjusts the color saturation.
• –9 to +9 (default: 0)
Notes
• The effects of the Video Adjust settings depends on the source
material and your TV, and in some cases may not be that visible.
• The Sharpness setting does not apply to video output by the
HDMI jack.
38
En
Fine
Standard
Soft
/ .
0
max

Initial Settings menu

The Initial Settings menu contains digital audio output,
video, language, display, and other settings.
When a menu item is grayed out, it means that it cannot
currently be changed. The Initial Settings cannot be
changed during disc playback.
1
Press DISC and then SETUP.
The Setup menu appears on-screen.
2
Select "Initial Settings", and then press
ENTER.
The Initial Settings menu appears on-screen.
Initial Settings
Digital Audio Out Digital Out
Video Output Dolby Digital Out
Language DTS Out
Display 96 kHz PCM Out
Options MPEG Out
3
Use / / / and ENTER to select and
change the settings.
The settings are explained below.
Notes
• The HDMI Resolution and HDMI Color settings only need to
be changed if you've connected an HDMI component to the
HDMI jack.
• The Component Out settings cannot be changed if you've
connected an HDMI component to the HDMI jack.
• The Component Out settings may change automatically due to
the HDMI Resolution and HDMI Color settings.
• While HDMI Audio is set to on (☞p.15), or a component is
connected to the HDMI jack, only the Digital Out setting is
available.
• When HDMI Audio is set to on (☞p.15), 96 kHz PCM is
downsampled to 48 kHz regardless of the 96 kHz PCM Out
setting.
■ Digital Audio Out settings
Digital Out
Turns the OPTICAL DIGITAL OUT on and off.
• On (default): OPTICAL DIGITAL OUT is on.
• Off: OPTICAL DIGITAL OUT is off.
Dolby Digital Out
Turns Dolby Digital to PCM conversion on and off. If
you've connected the OPTICAL DIGITAL OUT to your
AV receiver/decoder and it doesn't support Dolby Digital,
select Dolby Digital > PCM.
• Dolby Digital (default): Dolby Digital signals are
output as they are.
• Dolby Digital > PCM: Dolby Digital signals are
converted and output as 2-channel PCM.
On
Dolby Digital
DTS
96kHz > 48kHz
MPEG > PCM