Other Operations; Setting The Timer; Setting The Clock Timer - Yamaha MCR-840 Bedienungsanleitung

OTHER OPERATIONS

The receiver is equipped with 2 types of timer functions. The DVD player also turns on or sets to standby mode
automatically by the system control connection (☞p.8).

Setting the clock timer

The clock timer automatically turns the receiver on or sets
it to standby mode at the specified time. You can also
specify an input which the receiver automatically selects
when the clock timer turns it on.
Notes
• You cannot set the clock timer unless you adjust the clock
(☞p.13).
• If you do not touch any key for more than 30 seconds after the
previous key operation, the operations you made are cleared
from the memory and the normal display reappears.
TIMER indicator
INPUT
TP
TIMER
BASS
PHONES
INPUT
Input selection
keys
TIMER
ENTER
1
Press TIMER and
then press ENTER.
The receiver enters timer setting mode. The TIMER
indicator flashes on the front panel display.

SETTING THE TIMER

VOLUME
MIN MAX
TREBLE BALANCE
PRESET PURE DIRECT
L R
,
RETURN
/ to select "TIMER", and
2
Press or to select "ON" (timer enabled)
or "OFF" (timer disabled), and press ENTER.
ON: The timer clock setting screen appears. Proceed
to step 3.
OFF: The TIMER indicator turns off and the receiver
returns to normal mode.
Note
To disable the timer, select "OFF". Once the timer is enabled, the
timer setting and the TIMER indicator remain on until "OFF" is
selected.
3
Set the starting time of the timer.
For details on how to set the clock, see steps 4
through 6 of "Adjusting the Clock" (☞p.13).
4
Press / or an input selection key to select
the input source to be used when the timer
turns on the receiver, and press ENTER.
The receiver automatically selects the input source
when it is turned on by the clock timer.
If FM is selected as the input source, the preset
number (e.g. "P01") is shown on the front panel
display. Press / to select the preset number of the
station you want to hear when the timer is activated,
and press ENTER.
If you select "---" (default), the receiver selects the
station that you previously tuned in to.
If no station is registered as a preset station, "---" is
shown. Press ENTER and proceed to step 5.
You can only select a preset station. Register a station
that you want to hear when the timer is activated as a
preset station in advance (☞p.30).
Note
You cannot select AUX as an input source.
5
Press / to set the operation time length of
the receiver.
You can select a length of time from 30 to 90 minutes
in 10-minute steps. Select "--" if you do not want the
receiver to automatically go to standby mode.
6
Press ENTER to complete the timer setting.
The TIMER indicator lights up.
7
Press to set the receiver to standby mode.
The receiver will be turned on automatically at the
specified time.
33
En