Selecting The Output Type For Component Jacks; Selecting The Hdmi Audio Output; On-Screen Display (Osd) Language - Yamaha MCR-840 Bedienungsanleitung

Selecting the output type for
COMPONENT jacks
To use progressive display function, connect to a TV,
which has that function, via COMPONENT jacks.
1
Press SETUP.
2
Press to select "Initial Settings",
/ / /
and then press ENTER.
3
Press to select "Video Output", and then
/
press ENTER.
4
Press to select "Component Out", and
/
then press ENTER.
Initial Settings
TV Screen
Digital Audio Out
Video Output Component Out
Language HDMI Resolution
Display HDMI Color
Options
5
Press to select "Progressive / Interlace",
/
and then press ENTER.
6
When the confirmation screen appears,
press ENTER again.
To cancel the setting, press RETURN.
Note
Do not select "Progressive" if your TV does not have a
progressive display function.
If your TV is also connected via HDMI terminal, the system may
ignore this setting and output the progressive signal from
COMPONENT jacks.

Selecting the HDMI audio output

Normally, the speakers connected to the receiver are used
to output the sound. However, you may want to listen
through your HDMI TV's speakers, in which case you can
turn HDMI audio output on and off as follows.
1
Set the DVD player to standby.
2
While holding down
front panel, press
"DVD — NO REQ." is displayed.
3
Press /
OFF" or "HDMI A-ON".
4:3 (Letter Box)
Interlace
720x480p
Component
on the DVD player's
.
to select "HDMI A-
4
Press repeatedly to select "HDMI A-
ON".
5
Press .
HDMI Audio output is turned on and the DVD player
goes on standby. Press
To turn HDMI Audio output off, repeat the above
procedure but select "HDMI A-OFF" in step 4.
Note
The audio output by the HDMI jack is always 2-channel PCM.

On-screen display (OSD) language

You can select your preferred language settings so that the
DVD player will automatically switch to your preferred
language whenever you load a disc. If the language
selected is not available on the disc, the disc's default
setting language will be used instead. The OSD (on-screen
display) language for the DVD setup menu will remain as
you set it, regardless of various disc languages.
1
Press SETUP.
DVD setup menu appears on the screen.
2
Press to select "Initial Settings",
/ / /
and then press ENTER.
3
Press to select "Display", and then
/
press ENTER.
Initial Settings
Digital Audio Out OSD Language
Video Output Angle Indicator
Language
Display
Options
4
Press to select "OSD Language", and
/
then press ENTER.
5
Press to select a language, and then
/
press ENTER.
SETTING THE SYSTEM
again to turn it back on.
English
On
15
En