Remote Control; Dvd Player (Dvd-840) - Yamaha MCR-840 Bedienungsanleitung

Remote control

Problem
The remote control The remote control may be operated
does not work nor outside its operation range.
function properly.
The remote control sensor on this system
may be exposed to direct sunlight or
lightening (invented fluorescent lamps).
The battery may be worn out.
There are obstacles between the sensor of
this system and the remote control.
The system control cable is disconnected
from the system connector jack of the
receiver and/or the DVD player.

DVD player (DVD-840)

Problem
Power does not turn The plug is not completely inserted.
on.
The receiver and the DVD player are
connected incorrectly.
The receiver is set incorrectly.
Power suddenly The auto-standby function of the receiver
shuts off during
works when the receiver does not receive
playback. a playing signal transmitted from the
DVD player via the system control cable
for 30 minutes.
No sound or The sampling rate of a MP3, WMA or
distorted sound MPEG-4 AAC file may not be
compatible with the DVD player.
Disc playback does
You may use a recordable media that is
not start. not finalized.
The disc label may not be facing up.
The disc may be defective.
MP3/WMA/MPEG-4 AAC disc may not
contain sufficient music tracks to be
played back.
The sampling rate of a MP3, WMA or
MPEG-4 AAC file may not be
compatible with the DVD player.
The message "HDMI
The wrong HDMI resolution is selected
ERROR" is displayed or an HDMI error has occurred.
or there's no picture
on the HDMI TV.
Cause
For information on the remote control operation
range, see
Change the lighting or orientation of this system.
Replace the battery with new one.
Remove the obstacles.
Connect the receiver and the DVD player securely
with the system control cable.
Cause
Connect the power cable firmly.
Connect the system control cable properly between
the receiver and the DVD player.
Check the setting (INPUT/Volume/MUTE/
Headphone) of the receiver.
Check the connection of the system control cable
between the receiver and the DVD player.
Check the sampling rate and bit rate of the MP3,
WMA or MPEG-4 AAC file are compatible with the
DVD player.
Finalize the recordable media.
Place the disc in the disc tray with the label facing
up.
Try to play back another disc. If the same problem
does not occur, the disc you want to play back is
defective.
Check that your disc contains at least 5 MP3/WMA/
MPEG-4 AAC music files.
Check the sampling rate and bit rate of an MP3,
WMA or MPEG-4 AAC file are compatible with the
DVD player.
Check the HDMI Resolution setting and correct as
necessary.
Reset the HDMI settings.
Remedy
"Using the remote control"
.
Remedy
TROUBLESHOOTING
See
page
12
12
12
12
8
See
page
8
8
—
8
3
—
—
—
—
3
39
40
45
En