Using The Tp (Traffic Program) Data Service; Ct (Clock Time) Settings - Yamaha MCR-840 Bedienungsanleitung

RADIO DATA SYSTEM TUNING (EUROPE MODEL ONLY)
Using the TP (traffic program) data
service
Use this feature to receive the TP (traffic program) data
service of the Radio Data System station network.
TP indicator
INPUT
TP
TIMER
BASS
PHONES
TP
1
Tune into the desired Radio Data System
broadcasting station.
2
Press TP.
"TP SEARCH" flashes on the front panel display for
about three seconds, and the search starts.
The TP indicator on the receiver flashes during
search.
When the traffic program is received, the TP indicator
stays on and the search stops.
If you press TP, the search starts again.
If the receiver fails to receive the traffic program, the
TP indicator turns off and "NO TP" appears on the
display. The receiver returns to its previous state.
To cancel the search
Press TP during search.
32
En
VOLUME
MIN MAX
TREBLE BALANCE
PRESET PURE DIRECT
L R

CT (clock time) settings

You can use the CT information received from the Radio
Data System stations to adjust the built-in clock of the
receiver.
1
Press OPTION.
An option menu item appears on the front panel
display.
2
Press / to select "AUTO CLOCK", and
press ENTER.
3
Press / to select "ON" or "OFF", and
press ENTER.
The "AUTO CLOCK" status is displayed.
The default setting is "ON".
ON: Automatically adjusts the receiver clock using
the CT information.
OFF: Does not adjust the receiver clock.
To exit the option menu
Press OPTION.