Controls And Functions; Receiver (R-840) - Yamaha MCR-840 Bedienungsanleitung

CONTROLS AND FUNCTIONS

Receiver (R-840)

■ Front panel
1 234 5
INPUT
PRESET
TP
TIMER
BASS
PHONES
A BCD
1 INPUT
Selects an input source.
2 On/Standby indicator
Lights up in green when the receiver is turned on. Lights
up in amber when the receiver is in standby mode.
3 TP indicator
Lights up when the receiver is receiving a Radio Data
System station which contains the TP (traffic program)
data service (☞p.32).
4 Remote control sensor
Receives signals from the remote control.
5 PRESET indicator
Lights up when you select preset radio stations (☞p.30).
6 TUNED indicator
Lights up when the receiver is tuned into a station.
7 STEREO indicator
Lights up when the receiver is receiving a strong signal
from an FM stereo broadcast.
8 SLEEP indicator
Lights up when the sleep timer is on (☞p.34).
9 Front panel display
Shows the various information such as the tuning
frequency.
0 VOLUME
Adjusts the volume level.
A
(On/Standby)
Turns the receiver on or sets it to standby mode.
4
En
CONTROLS AND FUNCTIONS
67 8 9
VOLUME
TUNED STEREO kHz SLEEP MHz
MIN MAX
TREBLE BALANCE
PRESET PURE DIRECT
L R
E F G H
Front view
@
B PHONES jack
Outputs audio signals for private listening with
headphones.
C TIMER indicator
Lights up when the timer is set (☞p.33).
D BASS
Adjusts the low frequency response (☞p.17).
E TREBLE
Adjusts the high frequency response (☞p.17).
F BALANCE
Adjusts the audio output balance of the left to right
speakers to compensate for imbalances caused by speaker
locations or listening room conditions.
G PRESET d / u
Selects a preset station. The input source is changed to
FM. Operable even when the receiver is in standby mode
(☞p.30).
H PURE DIRECT
Turns on or off Pure Direct mode (☞p.17).
When Pure Direct mode is on, the indicator lights up in
blue.
I h / e
Starts and pauses the playback of iPod. The input source is
changed to iPod. Operable even when the receiver is in
standby mode.
J iPod dock
Connect your iPod (☞p.11).
iPod
I J
Top view