Direct Output/Send - Kemper PROFILER Bedienungsanleitung

Direct Output/Send

This carries the direct output signal in glorious mono. The main purpose for this output is to feed signals
into the reference amp while profiling. But it can do more than just that: you can also use the DIRECT
OUTPUT in combination with the RETURN INPUT to create an effects loop. In this case, the DIRECT OUT-
PUT becomes a mono send. If you"re not using this output as part of an effects loop, it will carry the origi-
nal guitar signal. So, if you want to record your guitar dry, connect the DIRECT OUTPUT to the recording
device or audio interface input.
✔ ✔
Note: The output purposes described here are just the standard settings. You can change the signal sourc-
es individually for each output in the Output Menu; e.g. you can set the Main Output to only deliver the
wet Delay and Reverb signal, while the Direct Output carries the pure amp sound without effects.
One or two passive linear speakers
(3)
Main Outs
Monitor Out
Input
Direct Out
BACK PANEL OVERVIEW 29