Kemper PROFILER Bedienungsanleitung Seite 12

12 KEMPER PROFILER
You can connect two pedals to control parameters such as volume or individual stomp parameters. Finally,
the PROFILER comes with USB connectors so you can connect it to your computer to transfer data and
update the firmware.
Choose your rig
A complete signal chain is called a "rig". Rigs consist of three sections located in the upper half of the
panel. The signal flow begins with the Input stage, and then moves through the three processing sections
at the top of the front panel of controls, and finally the OUTPUT stage. The order of the sections from left
to right represents the signal flow inside the PROFILER. Each section consists of three to four modules.
Each of the buttons in the signal flow gives you a unique and intuitive way to manage your sound. By
pressing a corresponding button, you activate each module or section. Holding the button a little bit lon-
ger will focus the module and show its parameters in the display. In the lower line of the display you see up
to four parameters that can be controlled by the soft knobs underneath. Tweak the knobs to change your
sound. If this module offers more than four parameters, you can navigate between pages using the Page
buttons. If you want to return to the main page, press EXIT.
If you changed a parameter setting, but want to return to the previous value, you can use the UNDO but-
ton on the left side of the display. It will always revert your most recent action. The REDO button will revert
the action of the UNDO button.
In Browse mode you can select the desired rig using the RIG buttons on the right side of the front panel.
The LEFT and RIGHT buttons will advance in single steps, while the UP and DOWN buttons will change
rigs in larger steps. You can also use the BROWSE knob above the right side of the display to see eight
rigs simultaneously, as well as scroll through the list of all available rigs. You can change the sequence of
rigs by using the soft button "Sort by ..." to sort them by date or author, and then load the selected rig
with soft button "Load".
Once you have found a rig that you like, you can use the soft knobs underneath the display to change the
gain and the EQ of the rig. These controls display their current value on the LED collar around the knobs.