Rig Navigation Section; Type Knob - Kemper PROFILER Bedienungsanleitung

16 KEMPER PROFILER
We already mentioned some of the buttons and knobs in the previous section, when we showed you how
to adjust the various effects and settings within the upper half of the front panel. Below is a short explana-
tion of what all of the front panel controls do

Rig navigation section

Here you can navigate through the rigs. LEFT and RIGHT buttons will switch sequentially, while the UP and
DOWN buttons will change in larger steps. A newly-selected rig is instantly recalled.

Type knob

(2)
When an effect or stomp is in the focus, the TYPE knob will select between different types of effect algo-
rithms. For example, in stomp edit this knob will select distortions, compressor and modulations among
others.
✔ ✔
When you switch between similar effects types, you will notice that parameters common to these effects
will retain their values; this is to make the choice of algorithm easier. For example, you can make a dedi-
cated setting for a Wah effect, and then step through the various Wah types; the effect will change, but
settings for the various ranges and Wah pedal control will remain the same. You can also switch the type
between phaser and flanger, to check the different impact of these two algorithms, and the modulation
scheme will remain unchanged.
In Browse Mode you can select from a number of different "Views". Each View filters the displayed rigs, to
help simplify the selection.
All Rigs No special view, you can see all rigs in your device.
Current Author Only rigs by the Author of the last selected rig will be displayed.
Favorites Only those rigs marked as favorites will be displayed. You can mark and unmark rigs as
favorites by holding the RIG button for two seconds.
(1)