Kemper PROFILER Bedienungsanleitung Seite 14

14 KEMPER PROFILER
Finally, you can select more stomps and effects in the EFFECTS section, and change the settings of the
delay and reverb using their dedicated knobs.
Stack
In the middle of this signal flow, you'll find the "stack" section with the buttons for AMPLIFIER, EQ (equal-
izer) and CABINET. The stack section represents the raw virtual guitar amplifier as defined by the profile.
In the stack section, you can freely combine amps and cabinets by holding their respective buttons to
bring them into focus, and then scroll through the available local presets using the BROWSE knob.
Effects
Here, you can add more built-in effects to the signal, after it has passed through the amplifier and virtual
cabinet. The delay and reverb module in the effects section have a fixed position and purpose. The knobs
underneath the signal flow give you direct access to the EFFECT MIX of the delay and reverb, as well as for
DELAY FEEDBACK and REVERB TIME.
The X and MOD modules offers you a further choice of effects. We recommend you place a modulation
effect into the MOD module, if you intend to use one in your rig, as you have direct access to its RATE and
INTENSITY parameters with the line of knobs underneath.
✔ ✔
The stomp, stack and effect section can be stored as an individual local preset. To recall an entire stomp,
stack or effect section, hold the respective section button and browse through the local section presets
using the BROWSE knob.