Configuring Network Settings Manually - Auerswald COMfortel 1400 IP Inbetriebnahmeanleitung

Select whether the account is to be used as default account or not.
10.
Note: If date and time are not yet configured in the PBX, only the name and
version of the telephone are displayed.
Further Steps
Configure the telephone according to your requirements. You can make the
configuration either with the telephone (see the Operation Guide of the tele-
phone) or with the configuration manager (recommended; see
If necessary, change the display profile to improve the contrast of the dis-
play (see the Operation Guide).
If necessary, make a firmware update in order to extend the telephone with
the newly available functions (see
tures is available on the Internet (see www.auerswald.de/service).

Configuring Network Settings Manually

Requirements
– Message Faulty network setup shown on the display during commission-
ing
Note: You can also find the manual network settings under
> Ethernet.
Tap on Faulty network setup.
1.
Tap on DHCP.
2.
Tap on IP address and enter a permanent IP address for the telephone.
3.
Note: By tapping on the required entry field, you can open an input assis-
tant for entering special characters.
Tap on OK.
4.
52
The account will be registered.
Date, time and name of the internal subscriber are displayed. The tele-
phone is now ready for use.
The Settings > Network app will be opened.
DHCP is switched off.
page 60). Information about new fea-
COMfortel 1400 IP - Firmware V2.4 - Setup V05 12/2015
page 59).
> Settings