Auerswald COMfortel 1400 IP Inbetriebnahmeanleitung Seite 51

Tap on the required language.
4.
Tap on Setup assistant.
5.
Under Options tap on Account from PBX.
6.
Note: Please observe the following notes if your telephone shows a differ-
ing or unexpected behaviour.
If the message Faulty network setup is shown on the display, this indi-
cates that the DHCP server is missing. You can also operate the telephone
with a permanent IP address. To do this, proceed as described in Configur-
ing Network Settings Manually on
this point.
If the setup assistant is started, but no account is displayed, the telephone
has not found any Auerswald PBX. If an Auerswald PBX is available, check
whether the corresponding PBX is switched on and start the search again.
To do this, tap on
able, you can also create an account and the corresponding VoIP provider
with the help of profiles. To do this, proceed as described in Manually Cre-
ating and Configuring a Standard VoIP Account for an Auerswald PBX on
page 53
page
the telephone, you can also configure VoIP providers and accounts inde-
pendently in the telephone. To do this, tap on Manual setup.
Tap on the required PBX.
7.
Tap on the desired account type:
8.
If you have selected the account type Standard VoIP account, select the
9.
country and enter the area code of your PBX and your internal number con-
figured in the PBX.
Note: The country configured for the selected account and the area code,
if entered, are already shown on the display. Tap on one of the fields to
change country or area code.
COMfortel 1400 IP - Firmware V2.4 - Setup V05 12/2015
The telephone searches for an Auerswald PBX in the network.
If the telephone has found an appropriate PBX, an account will auto-
matically be created for this PBX and will be displayed in the setup as-
sistant under Network search for Auerswald PBXs.
or Creating and Configuring Accounts for VoIP Providers on
55. If you do not want to use the profiles which are preconfigured by
Standard VoIP account: Enter your internal number configured in the
PBX as username and the corresponding password and tap on OK.
System telephony account: Enter your internal number configured in
the PBX as username and tap on OK. Enter the corresponding password
and tap on OK.
page 52
. If the search is not successful or if no PBX is avail-
and subsequently go back to
51