Manually Creating And Configuring A Standard Voip Account For An Auerswald Pbx - Auerswald COMfortel 2600 IP Inbetriebnahmeanweisungen

6.
Tap on OK.
7.
Tap on Gateway and enter a gateway.
8.
Tap on OK.
9.
Tap on DNS server 1 and then enter a DNS server.
10.
Tap on OK.
11.
Press the home key to get to the start page.
12.
Tap on No account registered.
13.
Proceed with
Manually Creating and Configuring a Standard VoIP Account for
an Auerswald PBX
Requirements
– Auerswald PBX COMpact 3000 analog/ISDN/VoIP, COMpact 4000,
COMpact 5010 VoIP, COMpact 5020 VoIP, COMpact 5000/R or
COMmander 6000/R/RX with the following features:



1.
Tap on (
2.
Tap on New provider/PBX.
3.
Tap on int Auerswald PBX sub system IPv4 V100.
4.
Tap on Domain and then enter the IP address of the PBX.
Note: To edit incorrect entries, tap on the required entry field and the
Android keyboard with a delete button opens. If you press the back key, the
Android keyboard closes.
5.
Tap on OK.
COMfortel 2600 IP/3600 IP - Firmware V2.4 - Setup V04 02/2016
The message No account registered is shown on the display.
The start up assistants starts automatically.
Step 7. on page
PBX put into operation
Available internal VoIP channels
Internal telephone number entered in the configuration with PIN and
password (COMpact 3000analogue/ISDN/VoIP until firmware 4.0N only
PIN)
Apps > Settings > Providers & PBXs).
Commissioning
55.
57