Auerswald COMfortel 2600 IP Inbetriebnahmeanweisungen Seite 55

PBX. Subsequently, the telephone starts, displays the start page, and is
ready for use. If the telephone starts with the language selection and the
setup assistant instead, you can enter the URL of the provisioning server
into the telephone. To do this, tap on Specify provisioning server and
enter the URL. You will find more information about the provisioning pro-
cess on the Internet (see
4.
Tap on the required language.
5.
Tap on Start setup assistant.
6.
Under Options tap on Account from pbx.
Note: Note the following notes if your telephone shows a differing or unex-
pected behaviour.
If the message Faulty network setup is shown on the display, this indi-
cates that the DHCP server is missing. You can also operate the telephone
with a permanent IP address. To do this, proceed as described in
ing Network Settings Manually on page 56
this point.
If the setup assistant has started, but no account is displayed, the telephone
could not find any Auerswald PBX. If an Auerswald PBX is available, check
whether the corresponding PBX is switched on and start the search again.
To do this, tap on
able, you can also create an account and the corresponding VoIP provider
with the help of profiles. To do this, proceed as described in
ating and Configuring a Standard VoIP Account for an Auerswald PBX on
page 57
page
the telephone, you can also configure VoIP providers and accounts inde-
pendently in the telephone. To do this, tap on Manual setup.
7.
Tap on the required PBX.
8.
Tap on the desired account type:


COMfortel 2600 IP/3600 IP - Firmware V2.4 - Setup V04 02/2016
The telephone searches for an Auerswald PBX in the network.
If the telephone has found an appropriate PBX, an account will auto-
matically be created for this PBX and will be displayed in the setup as-
sistant under Network search for Auerswald PBXs.
or Creating and Configuring Accounts for VoIP Providers on
59. If you do not want to use the profiles which are preconfigured by
Standard VoIP account: Enter your internal number configured in the
PBX as username and the corresponding password and tap on Done
and OK.
System telephony account: Enter your internal number configured in
the PBX as username and tap on OK. Enter the corresponding password
and tap on OK.
www.auerswald.de/service
. If the search is not successful or if no PBX is avail-
Commissioning
under Developer).
and subsequently go back to
Manually Cre-
)
Configur-
55