Commissioning; Commissioning The Telephone - Auerswald COMfortel 2600 IP Inbetriebnahmeanweisungen

This section describes the commissioning of the telephone. After the commissioning, you can
make internal calls. You can adjust the telephone to your requirements using the computer
configuration described at the end of this section.

Commissioning the Telephone

Note: If you want to integrate the telephone into an existing network, please
contact the responsible system administrator. Making changes to an exist-
ing network may cause considerable malfunctions.
Requirements
– The network cable delivered with the telephone
Note: If you require a longer or shorter network cable, use one without snap
tab protection. Otherwise, you may not be able to insert it far enough.
– For operation of a COMfortel 3600 IP with Power over Ethernet (PoE):
Bridge plug inserted into the power supply socket.
– For operation of a COMfortel 3600 IP with wall wart(s): wall wart(s) con-
nected to the telephone
– For operation of a COMfortel 2600 IP without PoE support: An additional
network cable and an PoE Injector as adapter between the power socket
and the Ethernet cable
– For operation as system telephone: PBX according to the proper use (see
Important Information > Proper Use)
– Internal telephone number entered during configuration with the corre-
sponding password of the telephone
– For automated configuration from a provisioning server: provisioning file
which is stored on the provisioning server and is known on the DHCP server
1.
Insert one cable end of the network cable into the PoE socket at the bottom
side of the telephone.
COMfortel 2600 IP/3600 IP - Firmware V2.4 - Setup V04 02/2016

Commissioning

Commissioning
53