Appendix; Requesting The Firmware Version/Serial Number; Performing A Firmware Update From The Sd/Sdhc Card - Auerswald COMfortel 2600 IP Inbetriebnahmeanweisungen

Appendix

Once you have put your telephone into operation and configured it, read this section on oper-
ation and configuration for additional useful information.

Requesting the Firmware Version/Serial Number

Tap on
1.
Scroll to the desired information.
2.

Performing a Firmware Update from the SD/SDHC Card

Important: You can download current firmware files from the Internet. (see
www.auerswald.de/service).
The Operation Guide of the telephone describes further alternatives of per-
forming a firmware update.
Requirements
– Firmware file (*.rom) saved on a SD/SDHC card
– SD/SDHC card inserted into slot (not included in the scope of delivery)
Tap on
1.
Tap on the firmware file (*.rom) displayed under Update from SD card.
2.
Tap on Update.
3.
Tap on:
4.
Further Steps
If the description of the new function is missing after the installation of a
firmware update, you will find current instruction manuals on the Internet
(see www.auerswald.de/service).
To use the new features after a firmware update of the telephone, an
update of the PBX firmware is often required (see instructions of the PBX).
62
Appendix
> Settings > About phone.
> Settings > Update & provisioning.
The message Update is installed, please wait... appears while the
firmware file is loaded into the telephone.
Restart later: The firmware will be activated the next time you restart the
telephone ( > Settings > Shutdown/Reboot > Reboot).
Restart now: The telephone restarts immediately and the new firmware
is activated.
COMfortel 2600 IP/3600 IP - Firmware V2.4 - Setup V04 02/2016