Commissioning
9.
If you have selected the account type Standard VoIP account, select the
country and enter the area code of your PBX and your internal number con-
figured in the PBX.
Note: The country configured for the selected account and the area code,
if entered, are already shown on the display. Tap on one of the fields to
change country or area code.
10.
Select whether the account is to be used as default account or not.
Further Steps
–
Configure the telephone according to your requirements. You can make the
configuration either with the telephone (see the Operation Guide of the tele-
phone) or with the configuration manager (recommended; see
–
If necessary, make a firmware update to add new functions to the telephone
(see
(see www.auerswald.de/service).
Configuring Network Settings Manually
Requirements
–
Message Faulty network setup shown on the display during commission-
ing
Note: You can also find the manual network settings under
> Ethernet.
1.
Tap on Faulty network setup.
2.
Tap on DHCP.
3.
Tap on IP address and enter a permanent IP address for the telephone.
Note: By tapping on the required entry field, you can open an input assis-
tant for entering special characters.
4.
Tap on OK.
5.
Tap on Net mask and enter a net mask.
56
The account will be registered.
Date, time and name of the internal subscriber are displayed. The tele-
phone is now ready for use.
page
62). Information about new features is available on the Internet
DHCP is switched off.
COMfortel 2600 IP/3600 IP - Firmware V2.4 - Setup V04 02/2016
page
60).
> Settings