Commissioning; Commissioning The Telephone - Auerswald COMfortel 1600 Installationsanleitung

This section describes how to commission the telephone and the answering machine on the
COMfortel 2600 for the first time in a stepwise procedure. After a successful initial commis-
sioning, you will be able to make calls. You can customise your telephone and the answering
machine using the PC configuration described at the end of this section.

Commissioning the Telephone

Requirements
– PBX switched on (connected to 230 V mains)
– The internal telephone number for the telephone entered in the configura-
tion on the internal S
Note: Only connect one ISDN device for each internal subscriber tele-
phone number to your PBX.
– For operation with COMfortel Xtension300 key extension modules: the wall-
mounted power supply type no. FW7577/EU/40
– For operation without COMfortel Xtension300 key extension modules: the
bridge plug is inserted into the socket marked with
the telephone
– For the operation as system telephone: PBX according to the proper use
(see Important Information > Proper Use)
1.
Insert the plug of the ISDN cable included in the package into the socket
marked with
2.
Insert the other ISDN cable plug into the ISDN socket connected to the
PBX.
3.
If required, insert the wall-mounted power supply type no. FW7577/EU/40
into a freely-accessible 230 V mains socket.
4.
Tap on the desired language.
5.
Use the keypad to enter the internal telephone number previously config-
ured in the PBX.
6.
Complete the entry:

COMfortel 1600/2600 - Firmware V1.8 - COMfortel Set V3.10.0 - Setup V06 05/2015

Commissioning

0
on the bottom of the telephone.
The telephone starts up. In the meantime, the Auerswald company icon
is shown on the display.
The menu for language selection is displayed.
COMfortel 1600: Tap on
or U port on the PBX
P0
.
Commissioning
at the lower side of
47