Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
144
Concentration mode
It is possible, in the event of an error, to refuse the value and to measure again. Press then on F2 key
[Discard].
- Then remake measurement while pressing on <START ENTER> key.
It is also possible, if the solution is unstable, to measure it again several times. The software will make the
average of the various measured values.
- To measure the solution once again, press F1 key [Next meas.].
- Press <START ENTER> key to measure the solution once again.
Remark: The number of times that the operator can measure again the solution is not limited.
The value will take in account is displayed under « Median » term.
- Press, then F4 key [Apply]. It displays:
The operator can choose to preserve the last measured value by validating the option "Last measured
absorbance" or to use the average value calculated by choosing and validating the option "Median".
It displays:
Werbung
Kapitel
Inhaltsverzeichnis
