Warning And Safety Instructions - Sl Analytics UviLine Sl 5000 Gebrauchsanleitung

122

2 Warning and safety instructions


Always make sure that the instrument is connected on the good voltage
(Between 100 – 240V 50-60Hz).

When substances dangerous for health and environment are used, the laboratory or site
rules, where the instrument is installed must be followed.

Take all the necessary precautions, during the use the instrument,
to protect the operator from eventual liquids leaks or spills or possible radiations
(protective gloves, anti-UV radiation glasses, protected clothes, etc.).
Keep the sample compartment clean.

The Xenon lamp used in the UviLine SI 7000/7100 emits UV radiation.

Install the instrument in a ventilated area because it is likely to generate ozone, which,
beyond the limits below, can harm health.

All operations made inside the instrument, must be done by SI Analytics® or by
SI Analytics' authorized technicians.

Using spectrophotometer without danger.

Use of the spectrophotometer without danger.
If it is necessary to suppose that it is not possible any more to use the spectrophotometer without
danger, it is necessary to put it out of service and to protect it from involuntary starting up again.
Use without danger will not be possible when the spectrophotometer
 suffered damage during transportation,
 was stored under inadequate conditions for a relatively long period,
 shows some visible damages,
 does not function as described in the user's manual anymore.
In case of doubt, consult the spectrophotometer supplier.
Warning and safety instructions
Exposure average value = 100 ppb
Exposure limits value = 200 ppb