Adding Water During Operation - Gastroback 42438 Design Tea & More Advanced Bedienungsanleitung

the water within the kettle or add water to the kettle, while the glass insert is
mounted within the kettle. Always remove the glass insert and glass insert lid set,
before pouring or adding water.
TIP: You may cancel any running program whenever you like. For this, simply hold
the "Start/Stop" button pressed for 3 seconds. To reduce energy consumption, it is
good advice to avoid leaving the appliance running uselessly.

Adding Water during Operation

If the filling level within the kettle drops below the MIN filling level (500 ml) during
operation, you need to add some water to the kettle.
1. By grasping both handles of the lid ring, lift the glass insert up and out of the
kettle. Place the glass insert onto the stainless steel bowl provided or on any other
suitable coaster.
CAUTION:
Do not let cold water run down at the side walls of the kettle, when
the kettle is hot. When adding water during operation, always pour the water slow-
ly into the middle of the kettle. Otherwise, the glass could crack! Please observe the
maximum filling level for operation with the glass insert (1100ml). Do not overfill the
kettle. Otherwise the water could splash during operation or run out, when replacing
the glass insert.
2. Pour the required amount of water slowly into the middle of the kettle.
3. Replace the glass insert in the kettle by holding the glass insert with the handles
of the glass insert lid ring. The kettle will heat the water up to the set temperature
and carry on executing the running program as normal.
Cooking Meals within the Kettle – "Boil" and "Custom"
Various meals can be cooked within the tea kettle (see: 'Recipes'). For this, it is best
to use the cooking programs "Boil" or "Custom". When putting your own ideas into
practice, please keep in mind that the temperature within the glass insert will be
slightly below the set temperature within the kettle. The higher the set temperature, the
higher the difference will be. Additionally, the difference will depend on the amount
of water within the kettle and the amount of food within the glass insert. To keep the
difference as low as possible, you should always use the glass lid and the stainless
steel lid of the glass insert lid set.
Note:
You should adapt the filling level in the kettle to the amount of food you wish to
cook/heat in the glass insert. With only a small amount of food in the glass insert,
you should reduce the maximum amount of water in the kettle to 700-800 ml.
64