Gastroback 42438 Design Tea & More Advanced Bedienungsanleitung Seite 62

1. Prepare the appliance for operation (see above: 'Preparing the Appliance for
Operation'). For this, fill the kettle with the desired amount of water between 0.5
litres ("500 ml/MIN") and 1.2 litres ("1200 ml/Tea MAX"). Do not overfilling
the kettle, to avoid overflow, when the water is boiling or the ingredients for your
tea are swelling up.
2. Fill the tea filter with the ingredients for your tea.
3. Place the tea lid ring on top of the kettle and press it down to fix it. Close the
opening in the lid ring with the tea lid.
4. Select the desired tea program by pressing the "Tea" button several times until the
desired program is indicated on the top line of the display (see: 'Tea Programs').
The pre-set temperature for each tea program is shown on the display.
Note:
With the tea program "Ice", only the steeping time can be set.
5. If you wish to change the temperature, turn the "°C/Time" knob, until the desired
temperature is displayed. Temperature values from 40°C to 100°C (boiling) are
possible.
6. If you wish to change the steeping time, press the "°C/Time" button for switching
to time display. Turn the "°C/Time" knob, until the desired time is shown. Time
values from 30 seconds (0m30s) to 10 minutes (10m00s) are possible. Using
the "°C/Time" button, you can switch between time and temperature as you like.
7. Press the "Start/Stop" button to start the program. The appliance will heat the
water within the kettle. As soon as the set temperature is reached, a signal sounds
and the "Start/Stop" button flashes. A count-up timer starts counting on the dis-
play.
WARNING:
removing the tea lid and the tea lid may be hot. Only touch the tea lid by the handle
and be aware of hot steam, when removing the tea lid.
8. Remove the tea lid and immerse the prepared tea filter into the kettle by hanging
the tea filter into the tea lid ring. If required, turn the tea filter on the lid ring until
it settles down. Thereafter replace the tea lid.
9. Press the "Start/Stop" button. The appliance will start a count-down timer with
the set time value and "Steeping" will appear on the left side of the display.
IMPORTANT: If you do not press the "Start/Stop" button, the appliance will wait
for approx. 10 minutes and thereafter shut off with an acoustic signal, to avoid use-
less energy consumption.
62
With high water temperature set, hot steam may escape when