High Temperature-Risk Of Burns; Technical Specifications; Properties Of Your New Water Kettle - Gastroback 42436 Design Wasserkocher Cool Touch Bedienungsanleitung

HIGH TEMPERATURE—RISK OF BURNS
The »Design Kettle Cool Touch« is equipped with
WARNING:
electric heating elements for heating up drinking water. Thus, the appli-
ance could cause severe scalds, burns and damage, when used improperly.
Always hold the kettle level when filled, to avoid spilling. The appliance
and the contents will be hot even for some time after operation. Always
leave the appliance cool down to room temperature, before cleaning or
storing the appliance.
Even with the lid properly closed, hot steam and splashes of hot water
could escape during operation. Do not hold your face or other parts of
your body over or directly near the appliance during operation and while
the appliance is still hot to avoid scalds due to steam and splashes.
In the area of the upper rim, even the exterior of the appliance will get
very hot during operation. Only touch the appliance at the operating ele-
ments and the handle, when it is hot. Before pouring, wait until the water
has stopped boiling and then pour carefully to avoid spilling. If the kettle
is tilted too much, the water could run out besides the spout, thus getting
spilled. Always keep the lid closed during operation and when the water
is boiling or still very hot, to avoid scalding.
Always keep the appliance in sufficient distance to the edge of the table
or counter and to other objects. For operation, leave at least 1 m of free
space above the appliance and at least 20 cm of free space on each
side, to avoid damage due to steam and hot water. Do not operate the
appliance under overhanging boards and drop-lights or near any delicate
objects (e.g. curtains) to avoid damage due to hot steam and water, over-
heating, and fire.
Do not hold your hands or any foreign objects (e.g. clothes, brushes) into
the interior of the kettle with the appliance connected to the power supply.
34

TECHNICAL SPECIFICATIONS

Model:
Power supply:
Power consumption:
Length of power cord:
Weight:
Dimensions: (width x depth x height)
Capacity:
Temperature:
Certification:
These specifications may change without notice.

PROPERTIES OF YOUR NEW WATER KETTLE

Your new »Design Kettle Cool Touch« is intended for heating up drinking water to a
selectable temperature in the range between 35°C to boiling temperature (100°C).
The selected temperature will be maintained for up to 30 minutes. Thereafter, the
appliance will shut-off automatically. Via the double-walled kettle, the energy loss
during operation is reduced significantly. You may cancel any operating cycle at any
time you like by pressing the ON/OFF button again.
IMPORTANT: Always close the lid for operation. With the lid open, the temperature
control and automatic shut-off will not work properly and there will be high energy loss.
IMPORTANT: Depending on the water hardness of your drinking water, the appli-
ance needs regular de-scaling (see: 'Care and Cleaning'). Otherwise, the tempe-
rature control will not work properly, there will be an increasing energy loss, and
overheating of the heating elements could occur.
DISPLAY
When connecting the appliance to the power supply, the actual water temperature in
the kettle is shown on the display. When pressing a temperature selection button or
the ON/OFF button the kettle will show the set temperature on the display. If you do
not press any button for approx. 6 seconds, the actual water temperature in the kettle
will be shown again. The water will be heated up to the set temperature and then
be kept at this temperature for up to 30 minutes with 3 dots flashing on the display.
IMPORTANT: After 30 minutes of being idle, the appliance will switch OFF com-
pletely and the display gets dark, to avoid useless energy loss.
Item No.: 42436 »Design Kettle Cool Touch«
220 - 240 V AC, 50/60 Hz
max. 1850 - 2200 W
approx. 70 cm
approx. 1.42 kg
approx. 226 x 154 x 234 mm
0.5 litres (MIN) to 1.5 litres (MAX)
variable from 35°C to 100°C
35