Operation - Gastroback 42442 Bedienungsanleitung

OPERATION

WARNING
reach of children younger than 8 years and animals. Do not leave the appli-
ance unattended, while it is connected to the power supply. Ensure that the
used power outlet is connected separately and rated for at least 16 A to avoid
overloading your power supply (see: 'Important Safeguards for Electrical Appli-
ances'). For operation, always unwind the power cord completely to avoid over-
heating, electric shock and fire. Ensure that the On/Off switch can move freely
and is not obstructed or defeated.
Ensure that the filling level is between the markings "500 ml / MIN" and "1700ml
/ MAX". Only fill in clear drinking water. Do not heat any other liquids or food or
foreign objects via the appliance.
If there are any liquids running out during operation, immediately unplug the power
base and remove the kettle from the power base.
Leave the Design Kettle Basic cool down, before filling it again. The glass body could
crack, when cold water runs down at the glass body, while the glass is still hot.
WARNING
splashes of hot water may escape from the spout. Even the exterior of the kettle
will get hot. Only touch the kettle by the handle and/or on/off switch.
1. Remove the kettle from the power base and pull out the lid. Fill the kettle with
the required amount of drinking water (filling level between "500 ml/MIN" and
"1700 ml/MAX"). Close the lid.
2. Ensure that the power cord is unwound completely and the exterior of the kettle
is dry. Place the kettle onto the power base and connect the appliance to the
power supply.
3. Push the on/off switch down. The on/off switch illuminates and the kettle starts
heating immediately. The appliance will shut off automatically, when the water
is boiling.
CAUTION
– If you wish to remove the kettle from the power base during
heating (on/off switch is illuminated), always switch off the kettle first (push the on/
off switch upwards). This will protect the electric connectors of the appliance from
damage.
4. After automatic shut-off, unplug the appliance, if you do not wish to use the appli-
ance again. Remove the kettle from the power base and wait until the water
stops boiling. Pour the water carefully, being aware of hot steam and splashes
that could escape during pouring.
– Always ensure that the appliance and all its parts are out of
– During operation and some time thereafter, hot steam and
EN
33