Herunterladen Inhalt Inhalt Diese Seite drucken

Preparing The Appliance For Operation - Gastroback 42438 Design Tea & More Advanced Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

IMPORTANT:
The maximum water temperature of the keep warm function is limited
to 90-95°C, because water will vaporize too quickly when kept at boiling tempe-
rature. Thus, the water level could fall easily below the minimum amount of 500ml.
Note:
Directly after the "Heating" phase, the actual water temperature within the kettle
could rise above the set temperature. Take this into account especially when using
only little amounts of water in the kettle and setting low temperatures.

PREPARING THE APPLIANCE FOR OPERATION

WARNING:
food or beverages within the kettle. There may be no cracks and chipped edges.
Even small splinters could cause severe injuries when getting into your food or beve-
rages.
1. Place the power base on the designated working place near an appropriate
wall power outlet (see: 'General Safety Instructions' and 'Important Safeguards
for Electrical Appliances').
2. Remove the kettle from the power base and remove the lid from the kettle.
3. Fill the desired amount of clear drinking water into the kettle. Ensure that the filling
level is above the MIN indicator ("500ml/MIN"). However, do not overfill the
kettle. Observe the maximum filling level depending on the intended task.
• Heating water: 1.5 litres ("1500ml/Water MAX");
• Preparing tea: 1.2 litres ("1200ml/Tea MAX");
• Using the glass insert: 1.1 litres (1100ml).
IMPORTANT:
Always keep the kettle level, as soon as it is filled. When filling the
kettle, ensure not to spill water on the exterior of the kettle. If required, wipe dry the
exterior of the kettle, before placing the kettle onto the power base.
4. Ensure that the exterior of the kettle is dry. Then place the kettle onto the power
base and connect the appliance to the power supply. A beep will sound and the
display will get illuminated. The first tea program ("Green") will be selected and
the set temperature of this program will be shown on the display. The appliance
is now ready for operation (standby mode).
Note:
You may cancel any operating cycle at any time via holding the "Start/Stop" but-
ton pressed for approx. 3 seconds until a signal sounds. The appliance will switch
back to standby mode.
60
Always ensure that glass kettle is undamaged, before preparing any

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis