Preparing Wheelchairs With Back Angle Adjustment For Transport; Fig. 24 Snail Symbol Indicating Creep Speed; Fig. 25 Cross Bolt Locked In The Holding Device - Otto Bock B500-S Bedienungsanleitung

fig. 24 Snail symbol indicating creep speed
8.1.6 Preparing Wheelchairs with Back Angle
Adjustment for Transport
To obtain the folding size, the following must be done with
the back angle adjustment:
r Release the cross bolt at the lower end of the gas
compression spring (by pushing up the lever, see arrow
in fig. 25).
r Remove the bolt from the holding device.
r Remove the side panels and fold down the back part
onto the seat bottom.
B500 | B500-S
fig. 25 cross bolt locked in the holding device
1 Cross bolt
2 Lock with lever
To put a wheelchair with back angle adjustment into
operation:
r Unfold the backrest.
r Insert the cross bolt at the end of the gas compression
spring into the holding device.
r Push down the lever to lock the bolt (see fig. 25).
ATTEnTIOn !
Verify that the bolt and lock of the back angle
adjustment are secure!
03/2010
Options
Page 131