Speed Controller - Reely 1601093 Bedienungsanleitung

Check the forward throttle function. Move the throttle lever (fig. 5, position 5) on the transmitter to continuously adjust
the speed of the model boat. The more you pull the trigger towards the handle, the faster the propeller will spin and the
faster the boat will move forward. The boat's propeller rotates in an anticlockwise direction (when viewed from behind).
Check the reverse throttle function. Move the throttle lever (fig. 5, position 5) on the transmitter to continuously adjust
the speed of the model boat. The more you push the trigger away from the handle, the faster the propeller will spin
and the faster the boat will move backwards. The boat's propeller rotates in a clockwise direction (when viewed from
behind).
The reverse throttle should only be used briefly, otherwise water may enter the hull via the shaft. In addition,
the water cooling system does not work when the reverse throttle is engaged.
Figure 9
d) Speed controller
The speed controller is cooled by the water cooling system. If the speed controller is not cooled properly, the power of
the speed controller will drop by 25 % when the internal temperature reaches +90 °C. If this occurs, bring the model
boat back to shore immediately and establish the cause of the problem.
The speed controller may overheat due to the following reasons:
• The water cooling system stops working (the hose is loose, blocked or kinked).
• Objects such as seaweed are blocking the motor
• The water temperature is too high, which prevents the speed controller from cooling properly.
If the speed controller does not receive a signal from the receiver, or the signal is weak, the motor will switch off
completely and the receiver LED will start to flash.
45