Reely 1601093 Bedienungsanleitung Seite 42

When the transmitter is switched on, the green frequency LED (F) on the right also flashes to indicate that the trans-
mitter is in pairing mode. In pairing mode, the transmitter attempts to connect to the receiver in the ready-to-start
model boat (the boat battery must be connected). After a few seconds (if pairing was successful), the green frequency
LED (F) will stay constant.
A trimmer (G) is located between the two LEDs. Use the trimmer to set the maximum possible rudder deflection (dual
rate function). Turn the trimmer to the left as far as it will go to set the rudder deflection to the minimum setting. To set
the rudder deflection to the maximum setting, turn the trimmer to the right as far as it will go.
The rudder system has a mechanical stop. When using the above-described trimmer (G) to set the rudder deflection,
ensure that the rudder will not block the servo at the maximum deflection setting.
Use the upper trimmer (H) to set the neutral position of the rudder. For example, if the model boat moves to the left
when the steering wheel (A) is in the neutral position, move the trimmer (H) to the right.
42