probst TM-D-A Betriebsanleitung Seite 12

General
3 General
3.1 Authorized use
The TRANSMOBIL device is a mobile transport and laying device for transporting a complete range of building
materials, as well as for lifting and laying concrete elements, natural stones, bricks, slabs, etc. with the appropriate
suction plates on the vacuum tube lifter.
In order to be able to use the largest possible working area, the installation should take place to the
right of the device.
The use of the device in closed rooms or explosion and fire hazard areas is prohibited due to
the diesel engine!
This device is equipped with the following elements as standard:
electronic, fully automatic mast alignment
•
The device is only designed for the use specified in this documentation.
•
Every other use is not authorized and is forbidden!
•
All relevant safety regulations, corresponding legal regulations, especially regulations of the
•
declaration of conformity, and additional local health and safety regulations must be observed.
Prior to every operation the user must ensure that:
• The equipment is suited to the intended operation
the functioning and the working condition of the equipment is examined
•
the load is suitable to be handled.
•
Any doubts about instructions should be raised with the manufacturer prior to use.
ATTENTION: The use of this device is only permitted in proximity to the ground (→ chapter
"Safety at work" and "Explanation of basic concepts").
The load (stone slabs) which is to be sucked and
•
transported, must have sufficient inherent stability,
otherwise there is risk of breakage when lifting!
Stone slabs must not be bend when lifting - especially
•
take care with thin and large-sized stone slabs!
Generally, the load (stones slab) is only to be sucked in
•
the middle, otherwise the load hangs diagonally under
the device which may cause a breaking of the load -
especially when lifting large stone slabs with a small
suction plate.
Standard suction plates are not suitable for the transport
•
of glass plates!
Only suction plates of the manufacturer PROBST shall be used!!!
52220015 / 52220015 -150 / 52220015-200 / 52220015-250 11 / 40 GB