probst TM-D-A Betriebsanleitung Seite 11

Safety
2.8.2 General
Before every usage of the device check the functions and the working condition.
•
Maintenance and lubrication are only permitted when device is shut down!
•
Do not use the device, until all faults which can cause safety hazards are removed.
•
• If there are any cracks, splits or damaged parts on any parts of the device, immediately stop using
it.
The operating instructions must be available at the workplace every time.
•
Do not remove the type plate of the machine.
•
• Unrecognisable information signs (such as regulatory or prohibition signs) must be replaced.
2.9 Safety in operation
Danger by wrong handling of the loads!
D not pull any loads in diagonal direction
•
Do not pull out stuck or tightened loads with the device
•
Do not lift any loads off-centre
•
The manual guiding is only allowed for devices with handles.
During operation, the operator must not leave the control position while the unit is loaded with
cargo and must always have the cargo in view.
Do not release the load until it is completely and safely resting on the ground.
Keep hands and feet away from the load! Danger of crushing!
The operator must always keep an eye on the pressure gauge.
Only lift the load when the required vacuum underpressure has been reached.
If the pointer of the pressure gauge moves into the red range, set down the load immediately!
If the working pressure drops below the required pressure, set down the load immediately!
Danger to life! Load will fall down!
52220015 / 52220015 -150 / 52220015-200 / 52220015-250 10 / 40 GB