Before activating sync, make sure that
your network! Else, the frame rate of Art-Net might drop. If you are not sure, do not
enable any sync mode.
Even if your Art-Net hardware does not support Pre Sync or Post Sync mode, it might
be advisable to activate it in MADRIX. In this way, data packages will be sent one
after another and will not get mixed up. The data will be sent more precisely. But
please make sure that all of your interfaces are available in the network.
In MADRIX, navigate to the menu 'Preferences'
and a new dialog will open. Now, choose if you want to activate sync packages to be sent before
data is sent ('Pre Sync'). Or you can send sync packages after Art-Net data has been sent (
'Post Sync'). Then, press 'OK'.
If you want to disable sync mode, click 'Sync' again and uncheck the mode that is selected.
Then, press 'OK'.
© 2013 inoage GmbH
MADRIX PLEXUS User Manual (English)
all
activated Art-Net devices are available in
'Device Manager'
'Art-Net'. Click 'Sync'
59