MADRIX PLEXUS Handbuch Seite 116

116 MADRIX PLEXUS User Manual / Handbuch
Group
Call up the PLEXUS Configuration dialog again. Go to the menu 'Tools'
(or 'Ctrl+Alt+P').
Select your device in the list. Change the settings for every required device, each at a time.
Please configure the column 'Group'!
The setting assigns your device to a certain group. In this way, you may set up several different
Master-Slave clusters (in the same network). It allows you to create several, independent groups.
Make sure that Master or Slave devices which should communicate with each other are assigned
to the same group!
PLEXUS Device Settings
Sync
Instead of using the PLEXUS Configuartion Dialog, you may check the settings on the device itself.
Navigate to the PLEXUS menu 'Network'
This menu shows the current settings regarding Master-Slave Synchronization of your current
PLEXUS Configuration.
You can check the Sync type (Master, Slave, Off) and Sync group (1 -256).
Also, check if Intensity (Enabled, Disabled), Intensity Group (Enabled, Disabled), Speed (Enabled,
Disabled) and Freeze (Enabled, Disabled) should be synchronized for Slave devices.
'Sync'.
'PLEXUS Configuration '
© 2013 inoage GmbH