Webserver - MADRIX PLEXUS Handbuch

124 MADRIX PLEXUS User Manual / Handbuch
DMX 1 -> Art-Net and DMX 2 -> Art-Net specify if the corresponding XLR port is used for DMX-IN
and if those incoming values should be broadcasted to the Art-Net network (Art-Net Remote).
As mentioned above, DMX-IN and Remote Control are two different features. If you are using
Remote Control and have DMX -> Art-Net activated as well, problems are very likely because the
Remote Control commands would be sent to the network as normal Art-Net data. Please avoid
such a configuration if not intended.
You may choose to create such a situation, for example when using Remote Control and having
configured Art-Net Stand-Alone (DMX data comes from the SD card and is sent to the Art-Net
network using this menu) or when using only 1 DMX universe. But please configure your DMX
Universes and DMX channels accordingly in order to avoid double usage of DMX channels.
Web Server
Introduction
The PLEXUS provides an integrated web server.
There two ways to gain access to this web server for remote control, directly via a web browser
or by using the PLEXUS Configuration dialog. Both ways will allow access to the interactive
demonstration in your web browser.
Using A Web Browser
1) Connect your PLEXUS as well as the remote device accessing the PLEXUS to a network (USB
will not work).
2) Open a web browser and type in the IP address of your PLEXUS. The IP address can be found
and changed in the PLEXUS menu 'Settings' 'Network'.
3) Once loaded, the page will show an interactive illustration of your device for remote control.
The graphical interface represents the menu of your PLEXUS in real time. In this way, you can use
various devices (such as smartphones, tablets, etc.) to control your PLEXUS remotely.
© 2013 inoage GmbH