Updating The Firmware; On The Device - MADRIX PLEXUS Handbuch

132 MADRIX PLEXUS User Manual / Handbuch
Fixed an issue with unintended display errors of file names during upload when a long file name
was followed by a short file name.
Fixed an issue with DMX-controlled Intensity Groups putting out a value of 100% when 39% is
set up (Remote Control).
Increased the timeout value to 20 seconds instead of 3 seconds for the display, when the SD
card is formatted.
Fixed an issue with prevented data upload or formatting of the SD card for Slave devices when
receiving live sync commands from a Master device.
PLEXUS driver supports detection and setup of Intensity Group settings (PLEXUS Configuration
dialog).

Updating The Firmware

1.4.2
Note
It is recommended to always use the latest firmware and drivers.
How To Check The Firmware Version

On The Device

version is 1.07.4369
On the device, navigate to the menu 'Info' 'Version'. The current
© 2013 inoage GmbH