MADRIX PLEXUS Handbuch Seite 100

100 MADRIX PLEXUS User Manual / Handbuch
'Valid Thru' defines together with 'Valid From' a time interval, in which the event will be
triggered. 'Valid Thru' sets the end point.
'Cycle defines a time period for the 'Type' 'Cycle' in HH:MM:SS (Hours:Minutes:Seconds).
Interval'
Extension Ports:
The tab 'Extension Ports' allows you to configure the individual pins of the extension port.
First, please select one PLEXUS Configuration you wish to edit.
Resets all settings of the currently selected Ports to their default value. This will discard
any changes you have made.
Please edit the following columns according to your requirements.
(Perform a double-click to change their values. Use Enter to apply your changes. Use Escape to
cancel.)
'Type' defines the character for each Port. On the one hand, 'Ports 1 - 6' can be either
'Digital Input', 'Digital Output' or 'Analog Input'. On the other hand, 'Ports 7 -
10' are only digital ports and can be switched from 'Digital Input' to 'Digital
Output' and vice versa.
'Invert' defines if the status of the Port (1 = On, 0 = Off) will be reversed to 0 = On, 1 =
Off.
© 2013 inoage GmbH