MADRIX PLEXUS Handbuch Seite 18

18 MADRIX PLEXUS User Manual / Handbuch
'Receive via' - specifies the source of remote commands. You can
choose to receive remote commands via DMX, via Art-Net, or to turn
remote control off.
'On port / On universe' - specifies for DMX which XLR port is used (DMX
1 or DMX 2) or for Art-Net which universe is used to send the remote
commands (1 to 256).
'Start channel' - specifies a DMX start channel (1 to 512). It defines
the range of DMX channels used for the set of remote functions. 20
DMX channels are used by the remote functions. The default value is 1.
'DMX -> Art-Net' - specifies if DMX-Thru is enabled, when Remote
Control is activated over DMX. Incoming DMX data would then
additionally be sent through to Art-Net.
You may change the settings in this menu, on the device (How To Edit
Values).
You can also configure the settings in the PLEXUS Configuration dialog
using MADRIX. For more information, see Managing Devices Further.
For more information, see the chapter Remote Control.
Monitor Remote Navigate to the menu 'Remote Control' 'Monitor Remote'.
Use this menu to monitor and check incoming DMX data for Remote
Control (DMX 1 or DMX 2). All 20 channels can be monitored using
hexadecimal values.
© 2013 inoage GmbH