MADRIX PLEXUS Handbuch Seite 16

16 MADRIX PLEXUS User Manual / Handbuch
'Show as' - Choose the overall display modus (Graphic, Table, Channel).
'Show values as' - Choose the display modus of values (Hexadecimal,
Decimal, Percent). Decimal cannot be displayed in Table mode.
Use or to scroll in Table mode.
Use or to change the DMX channel in Graphic and Channel Mode. In
Graphic mode, the individual channel will be shown in the upper right
corner in addition to the graphics.
Test Sending Navigate to the menu 'Tools' 'Test Sending'.
Use this menu to send DMX values for testing purposes.
Press or to change the DMX channel.
Minimum channel is 1. Maximum channel is 512.
Press or to change the DMX value that is being sent.
Minimum value is 0. Maximum value is 255.
Please note: You may reset the DMX value to its default value by
pressing " and " at the same time for 2 seconds.
You may change the settings and the functionality. Press and hold 'OK'
for 2 seconds.
'Send via' - Choose between the XLR ports ('DMX') and the Art-Net port
('Art-Net').
'Send on Universe/Send on Port' - Choose the first or second DMX
universe ('1', '2') or the Art-Net universe (1 - 256), respectively.
'Show values as' - Choose between decimal values ('Decimal'),
hexadecimal values ('Hexadec.') or percentage values ('Percent').
'Test mode' - Choose between three modes ('Channel', 'Universe', 'All
Channels'). Channel allows you to quickly change the DMX channels,
while the value will be saved and stays at the level you specified. All
other channels will be set to 0. Universe allows you to set up every
single channel with different values. The device will save the value for
each channel individually. All Channels will allow you to set up a DMX
value that is send to all channels of the DMX or Art-Net port.
© 2013 inoage GmbH