MADRIX PLEXUS Handbuch Seite 141

Blinking green
Fading between
green + red
Manually Installing The PLEXUS Driver
When Windows indicates that the hardware driver has not been installed correctly, please
manually update the driver.
In Windows, click 'Start'
Manager'. Right-click on 'MADRIX PLEXUS' in the section 'Other devices' and choose 'Update Driver
Software...'. Then, navigate to the driver location on your harddisk:
'C:\Program Files (x86)\MADRIX3\madrixusbdriver\plexus\windows'
Important Note
If new drivers and a new firmware are available for the MADRIX PLEXUS, please always
update the firmware first and the drivers second!
Hardware Model/Type
The manufacturer may update the hardware design of the device for new units. Please note the
following:
Hardware model V1.6 ('Model: PLEXUS V1.6') can be updated using firmware version 1.07.4369
or higher.
Hardware model V1.7 ('Model: PLEXUS V1.7') requires at least firmware version 1.06.4260 or
higher! Please do not use a previous version.
© 2013 inoage GmbH
Reading or writing data from or to the SD card.
The interface works correctly.
SD card is inserted.
The interface works; No data is read or written.
'Control Panel' 'System and Security' (or just 'System')
MADRIX PLEXUS User Manual (English) 141
'Device