MADRIX PLEXUS Handbuch Seite 14

14 MADRIX PLEXUS User Manual / Handbuch
Sync
DMX-IN input will be send over Art-Net to the configured Art-Net
universe via Broadcast according to the configured IP address and
Subnet mask of the device (Art-Net Remote).
Input can also be data from "Test Sending"
Input can also be the data sent by the SD card for Stand-Alone Mode.
In this way, Art-Net Stand-Alone can be configured. This means, the
PLEXUS runs a Stand-Alone show and the data is sent over network
(via Art-Net) directly to the LED fixtures or you could convert the data
to DMX again using a signal converter.
You may change the settings in this menu, on the device
Values).
You can also configure the settings in the PLEXUS Configuration dialog
using MADRIX. For more information, see
For more information about Art-Net output, see the chapter
(Output).
For more information about Art-Net Remote, see the chapter
Remote (Input).
Navigate to the menu 'Network'
This menu shows the current settings regarding Master-Slave
Synchronization.
You can check the Sync type ('Master', 'Slave', 'Off') and Sync group (1
-256).
Also, choose if 'Intensity' ('Enabled', 'Disabled'), 'Intensity
Group' ('Enabled', 'Disabled'), 'Speed' ('Enabled', 'Disabled') and
'Freeze' ('Enabled', 'Disabled') should be synchronized for Slave devices.
For more information, see
You may change the settings in this menu, on the device
Values).
(see
Managing Devices
'Sync'.
Managing Devices Further.
below).
(How To Edit
Further.
Art-Net
Art-Net
(How To Edit
© 2013 inoage GmbH