Tektronix TICP-Serie Benutzerhandbuch Seite 51

Remote programming
This sections describes commands and queries that can be sent to the sensor head when attached to a Tektronix oscilloscope. Long-form
and short-form keywords are indicated with upper/lower case letters. The commands and queries are supported by most oscilloscopes;
differences in supporting oscilloscopes, if any, are described with the commands.
For additional information, refer to the programmer documentation for your oscilloscope.
Command list
The commands and queries are supported by most oscilloscopes; differences in supporting oscilloscopes, if any, are described with the
commands. For additional information, refer to the programmer documentation for your oscilloscope.
CH<x>:PRObe? (Query Only)
This query-only command returns all information concerning the probe that is attached to the specified channel. The channel is specified
by x.
Syntax
Examples
CH<x>:PRObe:AUTOZero (No Query Form)
This command executes the AutoZero function. The operation is entirely performed by the oscilloscope. The channel is specified by x.
Refer to the self-calibration procedure for information on performing the self calibration.
Syntax
Arguments
Examples
TICP Series Active Isolated Current Shunt Probes User Manual
CH<x>:PRObe?
CH2:PROBE? might return 1.0000E-01; RESISTANCE 1.0000E+07;UNITS
"V";ID:TYPE "10X"'SERNUMBER "N/A" for a 10X probe, indicating that (among other
parameters) the attenuation factor for the probe attached to Channel 2 is 100.0 mV (assuming that probe
units are set to volts).
CH<x>:PRObe:AUTOZero EXECute
EXECute sets the probe attached to the specified channel to AutoZero.
CH1:PROBE:AUTOZERO EXECUTE sets the probe attached to the Channel 1 to autozero.
Self-calibration
Remote programming
51