SycoTec 4033 xC-C3 Gebrauchsanweisung Seite 63

7.4 Running-in process
• SycoTec recommends starting the motor spindle daily before initial commissioning and after the warm-up program.
• After a longer storage or standstill period and before the first start-up, the motor spindle must be run in again in
accordance with the following running-in instructions (grease distribution run of the spindle bearings).
• The motor spindle must not exceed a temperature of 40°C on the outside of the housing during the running-in process.
1. Interval with 25% of maximum speed
2. Interval with 40% of maximum speed
3. Interval with 60% of maximum speed
5. Interval with 40% of maximum speed
6. Interval with 60% of maximum speed
8. Interval with 60% of maximum speed
9. Interval with 80% of maximum speed
Operating time [sec]
Start-up cycle: Initial operation / out of use > 3 weeks (Operating time 11 min)
1. Interval with 25% of maximum speed
3. Interval with 25% of maximum speed
5. Interval with 40% of maximum speed
7. Interval with 60% of maximum speed
9. Interval with 80% of maximum speed
Operating time [sec]
1. Interval with 25% of maximum speed
3. Interval with 25% of maximum speed
5. Interval with 40% of maximum speed
7. Interval with 40% of maximum speed
9. Interval with 60% of maximum speed
11. Interval with 80% of maximum speed
Operating time [sec]
Start-up cycle: Daily warm up (Operating time 2 min)
4. Downtime
7. Downtime
0
2. Downtime
4. Downtime
6. Downtime
8. Downtime
0 20
Start-up cycle: Out of use > 3 moths (Operating time 30 min)
2. Downtime
4. Downtime
6. Downtime
8. Downtime
10. Downtime
0 50
10 sec
10 sec
10 sec
10 sec
10 sec
10 sec
5 10
60 sec
60 sec
60 sec
60 sec
60 sec
60 sec
60 sec
40 60
120 sec
60 sec
60 sec
60 sec
60 sec
60 sec
100 150
20 sec
20 sec
20 sec
15 20
120 sec
120 sec
80 100 120
240 sec
240 sec
300 sec
300 sec
300 sec
200 250 300
25
140
350
27 (EN)