SycoTec 4033 xC-C3 Gebrauchsanweisung Seite 41

1 General information
1.1 Note
• The operating manual contains important information about handling the product and must therefore be read carefully
before using the product. The product may only be put into operation if the operating manual has been fully understood.
If anything is unclear, please contact the manufacturer. The instructions in this operating manual must be followed.
• The operating manual must be available to the operator at all times and must be replaced immediately if lost or
rendered unusable. The obligation to retain the manual applies as long as the user is in possession of the product.
• The contents of this operating manual has been checked for conformity with the product described, but deviations and
errors cannot be ruled out. Technical and content changes, errors and misprints are reserved.
• This operating manual is subject to copyright and may not be reproduced, copied or modified in any form, in whole or in
part, without the written permission of the author.
1.2 Manufacturer
Name
Address
Phone
E-mail
Web
1.3 Product
The operating manual apply to the following product family:
Name
1.4 Labeling / type plate
For symbols used, see chapter
Each motor spindle is provided with a type plate on which the spindle type, serial number, performance data and important operating
values are indicated. The type plate shown is an example.
All necessary information can be requested from SycoTec using the labeled numbers REF (reference) and SN (serial number).
2 Safety instructions
2.1 Intended use
The motor spindle can be used in machines for the following machining processes:
Drilling, milling, engraving, grinding.
2.2 Target group
This document is intended for machine manufacturers and persons responsible for putting into service and operation of the motor
spindle.
SycoTec GmbH & Co. KG
Wangener Strasse 78
88299 Leutkirch im Allgäu
Germany
+49 7561 860
info@sycotec.eu
www.sycotec.eu
Motor spindle 4033 xC-C3
2.3
5 (EN)