Certified Configurations - Cmc Arizona Vortex Benutzerhandbuch

CERTIFIED CONFIGURATIONS

EN Standards
The Vortex is tested and certified to the following EN standards only as an Equal-Leg Tripod:
• EN 795:2012/B
• CEN/TS 16415:2013
NFPA Standards
MEETS THE PORTABLE ANCHOR REQUIREMENTS OF NFPA 1983, INCORPORATED IN THE
2022 EDITION OF NFPA 2500.
MINIMUM BREAKING STRENGTH AND RATING ARE DETERMINED AT THE CONFIGURATION
OF LOWEST STRENGTH PER MANUFACTURER'S INSTRUCTIONS.
RATED G (GENERAL USE), MBS 36 KN FOR THE FOLLOWING CONFIGURATIONS:
Configuration 1: Tripod
(all legs equal length)
• 2 outer legs coupled to 1 inner leg at maximum length
of 9 ft (2.7 m).
• Head unit connected to the inner leg via upper head pin
hole and last inner leg pin hole.
• Use either Raptor or Flat Feet.
• Legs at equal distance apart.
• Feet are required to be individually hobbled or anchored.
Configuration 2: Easel A-Frame
• A-Frame Section: 2 outer legs coupled to 1 inner leg at
maximum length of 8.5 ft (2.6 m).
• Easel Leg Section: 3 outer legs coupled to 1 inner leg at
maximum length of 10 ft (3.0 m).
• A-frame head unit connected to the inner leg via upper
head pin hole and third to last inner leg pin hole. Three
inner leg holes visible between head unit and outer leg.
• Easel head unit connected to the inner easel leg via third-
to-last leg pin hole. Three inner leg holes visible between
head unit and outer leg.
• A-frame section must be at 90 degrees relative to the
surface.
• Use either Raptor or Flat Feet.
• Easel leg to A-frame foot distance of 10 ft (3.0 m).
• Feet are required to be individually hobbled or anchored.
8'
8.5'
| cmcpro.com 5