Scheppach ACS3000 Originalbetriebsanleitung Seite 43

• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
17. Troubleshooting
Problem Possible Cause
The mains power lead is not
plugged in.
No power is coming from the
The sprayer
mains power outlet.
does not turn
The extension cord is damaged
on.
or has too low capacity.
The sprayer shuts of while under
pressure.
Spray tip (5) is clogged.
Suction hose is clogged.
Pressure control dial (9) turned
too low.
Little or no
material flow.
Suction hose is too loose.
Suction hose mesh filter (13)
clogged.
The nozzle guard nut (4) is loose. Tighten the nozzle guard nut (4).
Spray tip (5) was assembled
The spray tip
incorrectly.
leaks.
Spray tip (5) is worn.
Nozzle guard (4) is loose.
Spray tip (5) is worn.
Seal inside the nozzle guard (4)
Material
is worn.
leaking
Material building up spray tip (5)
and nozzle guard (4).
Material volume too large.
Spray Tip and Nozzle Guard
Atomization
clogged.
is too coarse.
Suction hose mesh filter (12)
clogged.
Pattern runs
Applying too much material
or sags.
Gun too far from spray object.
Too much
over-spray.
Too much material applied.
Action
Plug the mains power lead into a mains power outlet.
Properly test the power supply voltage.
Replace the extension cord with a suitable voltage.
Motor will cycle On and Off while spraying to regulate pres-
sure. This is normal.
Clean spray tip (5) using cleaning pin.
Clean suction hose (11).
Increase pressure dial control dial (9) setting by turning the
dial clockwise.
Re-adjust the suction hose (11) to the suction hose inlet port
(15) and use a flathead screwdriver to tighten the screw on
the metal hose clamp suction hose inlet port (16).
Clean or replace. Use the appropriate cleaning solution
depending on the material used.
Remove and assemble correctly.
Replace the spray tip /5).
Tighten the nozzle guard (4).
Replace the spray tip (5).
Replace the sealing (28).
Clean spray tip (5) and nozzle guard (4) by using the appro-
priate cleaning solution depending on the material used.
Decrease pressure control dial (9) setting.
Clean.
Clean or replace.
Adjust pressure control dial (9) or increase movement of
spray gun (6).
Reduce distance.
Decrease Pressure control dial (9) setting.
www.scheppach.com
GB | 43